BAT Scanner part one

here is my fixed template, I glued it to a piece of posterboard like I do all my papercraft and I glued the Convator belt to a piece of foamcore
because I wanted it sturdy enough to support a figure
you can see the original template in the picture as the bio viper machine, yea the BAT scanner could eat it.
resized 1000 percent in gimp from the original template, where the white tab is, that is where the top flap with all the controls is supposed to go
I had to figure that out on my own, the flap was attached to the bottom of that section making it impossible to be built
so if anyone sees the template on Joedios remember to cut that top flap off and glue it on as a separate piece. I can upload it if anyone wants it
mine is this large, takes up a whole sheet of standard A4 paper and the control/top flap is on a separate page with the convator belt as it should be.